商品の説明
1.充填する場合
対象物の表面を清浄にした後セパレータを剥ぎ取りあらかじめ充填物に合わせて成型し充填するか、または充填部に空気層が残らないように充填します。
2.対象物に巻く場合
対象物の表面を清浄にした後セパレータを剥ぎ取りながら巾が原巾の4/5程度(テープ巾が4〜5mm狭くなる程度)になるように均一に伸ばしながら1/2の重なりで対象物に巻付けます。
注意
寒冷時には少しあたためてから使用してください。夏季には直射日光下に置きますとセパレータが剥がれにくくなりますから注意してください。
用途
・ゴム、プラスチック電力ケーブル、制御ケーブルの分岐接続の場合のエフコテープ2号の巻き難い部分の充填物
・其の他絶縁を必要とする物でエフコテープ2号の巻き難い部分の充填物
・プラスチック絶縁通信ケーブルの接続部の絶縁および防水保護
※こちらは商品箱に表記してあるものです。ご確認の上ご使用ください。
エフコテープ1号は充填用絶縁材料です。必ず、エフコテープ2号を上に巻いてください。
エフコテープ2号で必要な絶縁性能を確保してください。
How to Use F-CO Tape No.1
1. Filing
Clean the surface of the object to be filled with the tape. Take off the separatorand apply the tape,preformed to fit the part to be filled or in such a manner as to make no voids in the filled part.
2.Winding
Clean the surface of the object to be taped.
White taking off the separator,wind the tape half-lapped,stretching it evenly to the extent that its original width is reduced to about 4/5 (4〜5mm less)
Caution
In the cold season,warm the tape before use.
In summer,keep the tape away from the direct rays of the sun,otherwise the separator will become hard to take off.
Uses
1.Filling of such part of branch joint of rubber or plastic covered power of control cable as is hard to wind with F-CO Tape No.2
2.Filling of such part of an object to be insulated as is hard to wind F-CO Tape No.2
3.Insulation and waterproof protection of the joint of plastic insulated communication cables.